What is the technique of painting the paint in the anticorrosion wood pavilion?
Anticorrosion wood arbor paint has two advantages, one is beautiful (although the wood itself is very beautiful), but can effectively protect the anticorrosion wood Pavilion。 So how can the anticorrosion wooden pavilion brush the paint? Below Guizhou anticorrosion wood small editor to give a brief introduction for you。
Anticorrosive wooden pavilion
优中彩票官网Figure 1 anticorrosive wood Arbor
优中彩票官网First, when constructing the construction site for the preservation of wooden pavilion, the stacking of wood must have 10-12mm gaps on each floor, and prevent the direct illumination of rain or sunshine.
Two, during construction, it is necessary to make reasonable and effective use of the existing scale of existing wood. If we need to cut and drill holes, it is necessary to use preservatives to make up the brush to ensure the integrity of the coating.
Three, in the time of connection, it should be drilled in advance so as to prevent the anticorrosion wooden pavilion from cracking in the future.
Four, all links are necessary to use hot dip galvanized fasteners, perhaps stainless steel hardware, in order to prevent corrosion.
Five。 In order to make the anticorrosive wood Pavilion more beautiful, we should use long wood to cut the joint as far as possible when building the antiseptic wooden pavilion, and there should be 3-7mm gap between the plate and the surface。
Six. The adhesive used in the anticorrosion wood Pavilion should be waterproof and weatherproof.
Seven, field construction of antiseptic wooden pavilion, after completion of construction, we should do maintenance work, such as brushing oil and so on, to prevent the occurrence of wood cracking and deformation due to sun and rain。
Eight, if you want to paint, you must choose water-based anti UV paint, and wet wood is not suitable to paint。
Nine。 In order to prevent the deformation of wood and wood with thickness exceeding 35mm, it is suggested that a small slot of 10*10mm be opened at the center line of the wood core。
Ten。 The different application environment (such as the ground, lower or water) should be used as a different grade of anticorrosive wood to ensure the planning service life。
In addition, there are several points to be paid attention to when setting up the anticorrosion wood arbor.
1. must be processed at a temperature above 8 degrees centigrade.
2. the wood is necessary and dry, and the highest water content does not exceed 15%.
3. painted wood wax before the anti-corrosion timber with fine emery cloth polishing, and wipe to smooth surface. The appearance of wood, such as fiber, can be sanded quietly by P240 or above.
4。 before the use of full mixing, without dilution, if the product viscosity is high, also can be mixed with a small amount of special diluent, the amount of participation should not exceed 10%。
5. use a soft bristle brush along the direction of the thin wood texture, uniform brushing, brush after brushing to remove excess wax oil, the amount must be less, not painted too thick; the appearance of the object to be coated after work, grinding, quietly wipe, 12 hours with second times.